Mobile phone chargers available in the market are quite expensive. The circuit presented here comes as a low-cost alternative to charge mobile telephones/battery packs with a rating of 7.2 volts, such as Nokia 6110/6150.

Circuit diagram:

Parts

•R1 = 1K
•R2 = 47R
•R3 = 10R
•R4 = 47R
•C1 = 1000uF-25V
•D1 = LEDs any color
•D2 = LEDs any color
•D3 = LEDs any color
•D4 = 1N4007
•D5 = 1N4007
•IC1 = LM7806
•T1 = 9VAC Xformer 250mA

•BR1 = Diode bridge 1A

Circuit Operation:

The 220-240V AC mains supply is down-converted to 9V AC by transformer T1. The transformer output is rectified by BR1 and the positive DC supply is directly connected to the charger’s output contact, while the negative terminal is connected through current limiting resistor R2. D2 works as a power indicator with R1 serving as the current limiter and D3 indicates the charging status. During the charging period, about 3 volts drop occurs across R2, which turns on D3 through R3.

An external DC supply source (for instance, from a vehicle battery) can also be used to energies the charger, where R4, after polarity protection diode D5, limits the input current to a safe value. The 3-terminal positive voltage regulator LM7806 (IC1) provides a constant voltage output of 7.8V DC since D1 connected between the common terminal (pin 2) and ground rail of IC1 raises the output voltage to 7.8V DC. D1 also serves as a power indicator for the external DC supply. After constructing the circuit on a veroboard, enclose it in a suitable cabinet. A small heat sink is recommended for IC1.

Prev:How to Connect VGA to an HDMI TV

Next:How to Install a Digital Antenna

Leave a message

Message List

Comments Loading...

Products Category

Products Tags

Fmuser Sites

Mobile Phone Battery Charger Circuit

Leave a message

Message List