News-FMUSER FM/TV Broadcast One-Stop Supplier

How to Reduce the Volume of a Guitar Amp Using an Attenuator

Many modern guitar amplifiers have very effective master volume controls that allow you to play a high-wattage amplifier at lower volumes and still get great tone. But a fair number of vintage amps don’t have master volumes, and some amps that do have them don’t sound their best unles

Posted on:01-03 View:34
How to Reset the Antelope Audio Zen Studio

To reset an Antelope Audio Zen Studio, hold the up and down arrow buttons while plugging in the power cable. This will put the device back to its default factory state.

Posted on:01-03 View:25
How to Restart EUCON Apps

Avid’s EUCON is a network protocol that allows control surfaces to deeply integrate with DAW software. It communicates using ethernet, IP addresses, etc. For this to work, generally the gear has to be connected properly, then turned on in the proper order so that addresses can b

Posted on:01-03 View:15
How to Restore Orion 32 Factory Default Settings

To return an Antelope Audio Orion 32 audio interface to its factory default state, press and hold the Antelope button on the front panel, then press the Preset 1 button.

Posted on:01-03 View:38
How To Seal Gaps In A Studio

Q: I’m installing double drywall in the studio I am building in my basement, but how do I seal the gaps around outlets, the corners, etc.? A: You definitely want to seal the room as much as possible. The more airtight it is, the more sound transmission will be reduced. The

Posted on:01-03 View:28
How to Set Up Multichannel Plug-ins in Ableton Live

In this article we’ll take a look at how to route a multi-channel plug-in, such as Sampletank 3 from IK Multimedia, inside Ableton Live so tat you can get the most out of the plug-in while efficiently using your computer’s memory. Sampletank 3 is a 16-channel multitimbral ins

Posted on:01-03 View:81
How to Stereo Link Two Mono 527 Modules in an API Lunchbox

These days, API 500-format modules are available in all kinds of configurations, including stereo. However, for a long time, only mono modules were available. Some of these modules allowed for stereo operation with some very simple “surgery” — jumping two pins together. For example

Posted on:01-02 View:49
How To Troubleshoot Your Signal Path; Part 2

Part one was a mental checklist for signal-path triage, designed help get you out of a gig emergency; part two goes beyond the more obvious points into a diagnosis of more serious signal-path ailments. If you’ve already answered the questions in part one and are still experiencing

Posted on:01-02 View:46
How To Troubleshoot Your Signal Path — Part 1

We’ve all been there: Everything worked fine at soundcheck but when you strike the first chord at show time all you hear is silence. Don’t panic; I’ve compiled a checklist to help get you up and running again quickly and efficiently. I’ll be using a guitar rig as my example sinc

Posted on:01-02 View:25
How to Use a “Bit-crusher” Plug-in to Add Warmth

There are a whole lot of tape and tube emulation plug-ins available to help give your tracks and mixes that analog style warmth and “glue.” These work great! But sometimes, you might want that glue for your mix, but with less of a vintage sound. Time to reach into the toolbox fo

Posted on:01-02 View:33

Previous 443444445 446 447 Next

Products Category

Products Tags

Fmuser Sites