Furman M8S

15A Standard Power Conditioner W/Power Sequencing, 9 Outlets, 1RU, 10Ft CordBSW PART: M8S

Merit M-8S Power Sequencer is the perfect low-cost AC power solution for any rack mount system. Install an M-8S in your rack, and the eight outlets in the rear panel will power up in sequence and protect all your equipment up to a 15-amp load.

Main Features

* Standard level AC protection and filtering.

* Six sequenced rear panel outlets (in 3 groups), two unswitched rear panel outlets, and one front panel unswitched outlet.

* Momentary and Maintained sequencing via rear panel terminal block or front panel switch (momentary only).

* All settings and configurations available on rear panel.

* 15 amp rating.

* Three year limited warranty.

Specifications:

* Maximum Output Current: 15 amps, 120 VAC (Thermal breaker)

* Line Cord: 14AWGx3, 10 feet, black, fixed, NEMA 5-15P plug

* AC Receptacles:

* Convenience Outlet (Front Panel) 1 Un-switched NEMA 15-5R

* Rear Panel Outlets: 2 Un-switched NEMA 5-15R (1 duplex),

* 6 Sequenced NEMA 5-15R (3 duplexes, each controlled by separate relay)

* Standard level AC Surge Protection : Merit Class (sacrificial)

* Spike Protection Mode : Line to neutral, zero ground leakage

* Max Continuous Operating Voltage : 130V RMS

* Max Clamp Voltage : 500 Volts Peak

* Peak Impulse Current : 12,000 Amps

* Energy Rating (2 X 820**S) : 225 Joules

* AC Filtering : Standard level Pi LCR Filter

* Noise Attenuation : >26dB, 100 Khz to 1 MHz

* Operating Temperature Range : 5C (40F) to 40C (105F) degrees

* Humidity Range : <90% rH (Relative Humidity)

* Rocker Switch : Front panel, Sequence (ON, OFF)

* Thermal Circuit Breaker : Front panel, push to reset

* Front Panel Indicators : Delay 1, Delay 2, Delay 3, Power, Protection OK

* Rear Panel DIP Switches : 12V Mode On/Off, GND Mode On, Momentary/Maintained

* Potentiometer : Rear panel, time calibration fine tune delay adjust

* Remote Terminal : +5-30VDC In, 12VDC (12mA) Out

* Remote Terminal : Phoenix type 4-Pin Connector with Screw terminals; +12V, STAT, REM, GND (Class 2 Wiring)

* Dimensions : 19"L x 8.75"D x 1.75"H a€“ ANSI 1RU

* Weight : 7 lbs.

* Power Consumption : 5 Watts

* Safety Agency : C/CSA/US

Leave a message 

Message List