RDL ST-LCR1

Non Latch Logic Control RelayBSW PART: STLCR1

The ST-LCR1 provides double-pole, double-throw dry switching contacts and LED indicator for relay closure. The ST-LCR1 provides momentary operation and is ideally suited where additional switching contacts are needed to be added to nearly any type of control signal.

Main features:

* Add Contacts to Any Control Signal

* Activation from Logic Circuits

* DPDT Switching Relay

* Open-Collector Switching

* Control from Switch, Button or Logic Circuits

Specifications:

* Control Inputs:SLAVE terminal used as an input from remote push-button or switch turns on relay when that switch is on. Activation is by connecting this input to Ground. Input from other equipment's open-collector output turns relay on when open-collector is on.

Note: RDL switching STICK-ONs have open-collector outputs suitable for driving an ST-LCR1. 5V+ accepts 3.5 to 12 Vdc to turn on relay. Relay is on only when this control signal is applied. 24V+ accepts 12 to 35 Vdc to turn on relay. Relay is on only when this control signal is applied.

* Control Output:SLAVE terminal open-collector @ 25 mA suitable to drive indicators or slave LCRs

* Switching Contacts:Double-pole, double-throw

* Maximum Switching Power: 60 W (220 Vdc, 125 Vac, 2 A)

* Power Requirement:GROUND-REFERENCED, 24 Vdc @ 50 mA * * Assumes 20 mA max load at SLAVE output

* Ambient Operating Environment:-10° C to 55° C

Leave a message 

Message List