Add Favorite Set Homepage
Position:Home >> News

Products Category

Products Tags

Fmuser Sites

RF combiner, splitter / divider basics​

Date:2014/3/27 15:32:57 Hits:

RF combiner, splitter / divider basics

- overview and introduction to the basic concepts of RF combiners and RF splitters

RF combiners and splitters are widely used in RF applications. The enable RF power to be split or combined within an environment where the characteristic impedance is maintained.
RF power combiners and RF splitters are the same items. The same circuits can be used to combine and split RF power, the only difference being that RF power is applied to one port and extracted from other in the case of the RF splitter, and for the RF combiner, power is applied in the opposite direction.

Types of RF splitter combiners


There are two broad categories of RF splitters:

-Resistive power splitters:   As the name implies, these power splitters and combiners use resistors. While they are able to maintain the characteristic impedance of the system, the use of resistors introduces loss above that of the minimum caused any splitting action. They are cheap and easy to make.
-Hybrid power splitters:   Hybrid splitters use transformers and are able to provide low levels of loss. Although there are some physical losses in the transformer, the major "loss" is that arising from the splitting process as the same signal is shared between a number of outputs.

Power splitter insertion loss

When a splitter is inserted into a circuit, there are naturally some losses resulting from the fact that no component is perfectly lossless. These losses are generally minimised and cannot be calculated exactly.


However there are also "losses" resulting from the fact that the signal is being divided between several outputs. This should more accurately be described as a division signal reduction as none of the signal is actually lost. Instead there is a level reduction fromth e fact that the input power is being shared amongst several outputs.
This power reduction can be calculated and table of the levels for power splitters with different numbers of outputs is given below.


In addition to these figures for level reduction, there are real signal losses arising from the use of imperfect or real components. These losses will need to be added to the figures above for each output.

Leave a message 

Name *
Email *
Phone
Address
Code See the verification code? Click refresh!
Message
 

Message List

Comments Loading...
Home| About Us| Products| News| Download| Support| Feedback| Contact Us| Service
FMUSER FM/TV Broadcast One-Stop Supplier
  Contact Us